What is the cause of blisters after cupping and how to prevent it?
 Encyclopedic 
 PRE       NEXT 
  Sometimes the cupping of fire cupping did not grasp the time, will cause to stay cupping time is too long to cause local skin blisters. So what is the reason for the blisters of cupping, how should we prevent it? Next, I will give you a detailed introduction.

  Blisters, be sure not to uncover the blister epidermis, you can local disinfection, the use of sterile scissors in the blisters of the bottom edge of the blisters will be cut open, the opening can be larger, and then appear to ooze out of the time can flow out of the local or the need to apply the scald cream of wet burns cream (Meibao) is a very good drug. There is another method, cupping cupping blisters do not worry too much, this situation is also more common clinical, you can use a sterilized needle to pick it, and then rub iodine can be, the wound do not water, to avoid infection.

  According to the number and size of the blisters, take wheat or raw rice (all with dry, wheat is best), chewed into a paste with the teeth, covered in blisters, fixed with medical cotton wool and medical tape, after a few hours the blisters in the water sucked out, there is no discomfort, after a few days of crust will fall off, without leaving scars. There are blisters to prove that the dampness is heavy. But you can't pull again in the blistered place, you can change a few more places. At the same time, be careful not to get infected. Dampness is heavy, at the same time, there will be body weight, always sleepy performance, diet must avoid cold food.

  What is the cause of blisters in cupping and how to prevent them?

  What is the cause of blisters from fire cupping?

  After fire cupping sometimes local skin in addition to bleeding spots, ecchymosis and other phenomena, some patients will appear blisters, mainly due to the following reasons:

  1、Wind-cold-dampness and dampness are more prevalent in the patient's body, with dampness being the most prominent. Blistering is also a kind of manifestation of the outflow of evil qi. Sometimes small drops of water appear on the walls of the canister, which is also a manifestation of dampness.

  2, leave the jar time a little long. This varies from person to person and is also related to the body type. Some people stay 20-30 minutes will not have blisters, and some people will blister in 5-10 minutes. So generally the first cupping time needs to be shorter, and so on the patient's situation to understand, you can properly relax the time.

  3, the canister temperature is higher, which is only a small possibility. Sometimes do flash cupping, if it causes the temperature of the canister to be too high, then leave the canister, it will increase the possibility of blistering.

  4, the difference between the parts, the same person cupping, some parts of no problem, some parts of the blister. The general rule is that the back, two coercive, buttocks easy to blister.

  5, cupping too heavy, beyond the capacity.

  What is the reason for blisters in cupping and how to prevent them?

  How to prevent cupping blisters

  Experts suggest that attention to the following cupping matters can effectively prevent blisters:

  First, in the application of walking cans, can not be in the bone protruding push and pull, in order to avoid damage to the skin, or fire can leakage off.

  Second, the position must be appropriate, local flesh, such as wrinkles, flaccid, uneven scars and position movement, etc., the fire cans are easy to fall off.

  Third, in the application of needle cans, must prevent muscle contraction, the occurrence of bending the needle, and to avoid the needle into the depth of the pressure, in favor of injury. Chest and back acupuncture points should be used with caution.

  Fourth, when the cans should be gentle, with one hand against the skin on the side of the cans, press a little, so that the gas leakage, the cans that can be removed, not hard pull or spinning.

  Fifth, in the application of blood cupping, needle skin bleeding area, equal to or slightly larger than the caliber of the fire can. The amount of bleeding shall be appropriate, and the total amount of each time shall not exceed 10ml for adults.

  Sixth, in the use of multiple cans, the distance between the cans arranged generally should not be too close, otherwise the skin will be pulled by the cans will produce pain, and at the same time due to the cans crowded each other, it is not suitable for pulling firmly.

  According to different parts of the body, use the right size of cans. When applying fire cupping, the flame should be strong, and the action should be fast, so that the mouth of the can is tilted upwards to avoid the fire source falling down and burning the skin. When applying the flash fire method, the cotton swab dipped in alcohol should not be too much, in order to prevent the alcohol from dripping down to burn and injure the skin. With the cotton method, to prevent burning cotton off. When using the rack fire method, buckle cover to be accurate, do not knock over the burning fire rack. When using a boiling water pot, the hot water in the pot should be thrown away to avoid scalding the patient's skin.

  Eight, after cupping pinhole if bleeding, can be used to dry cotton ball swabbing. General local redness or cyanosis (bruising), is a normal phenomenon, will subside on its own. If the local bruising is serious, it is not suitable to pull again in the original position. If the canister is left for too long, the skin will blister, small do not need to deal with, to prevent infection caused by abrasion; large can be pierced with a needle, outflow of the liquid in the bubble, coated with gentian violet solution, covered with sterile dressings, to prevent infection.

  Cupping of blisters is what causes, how to prevent to this for you to introduce the end, I hope our introduction can help you, and finally wish you good health in this winter, all the best.




 PRE       NEXT 

rvvrgroup.com©2017-2025 All Rights Reserved